HP MSR2000/3000/4000 Router Series IP Multicast Configuration Guide

149
Displaying and maintaining IPv6 PIM
Execute display commands in any view.
Task Command
Display BSR information in the IPv6
PIM-SM domain.
display ipv6 pim [ vpn-instance vpn-instance-name ] bsr-info
Display information about the
routes used by IPv6 PIM.
display ipv6 pim [ vpn-instance vpn-instance-name ] claimed-route
[ ipv6-source-address ]
Display C-RP information in the IPv6
PIM-SM domain.
display ipv6 pim [ vpn-instance vpn-instance-name ] c-rp [ local ]
Display IPv6 PIM information on an
interface.
display ipv6 pim [ vpn-instance vpn-instance-name ] interface
[ interface-type interface-number ] [ verbose ]
Display IPv6 PIM neighbor
information.
display ipv6 pim [ vpn-instance vpn-instance-name ] neighbor
[ ipv6-neighbor-address | interface interface-type interface-number |
verbose ] *
Display IPv6 PIM routing table
information.
display ipv6 pim [ vpn-instance vpn-instance-name ] routing-table
[ ipv6-group-address [ prefix-length ] | ipv6-source-address
[ prefix-length ] | flags flag-value | fsm | incoming-interface
interface-type interface-number | mode mode-type | outgoing-interface
{ exclude | include | match } interface-type interface-number ] *
Display RP information in the IPv6
PIM-SM domain.
display ipv6 pim [ vpn-instance vpn-instance-name ] rp-info
[ ipv6-group-address ]
IPv6 PIM configuration examples
IPv6 PIM-DM configuration example
Network requirements
VOD streams are sent to receiver hosts in multicast. The receiver groups of different organizations form
stub networks, and at least one receiver host exists in each stub network. The entire IPv6 PIM domain is
operating in the dense mode.
Host A and Host C are IPv6 multicast receivers in two stub networks N1 and N2.
MLDv1 runs between Router A and N1 and between Router B, Router C, and N2.