HP MSR2000/3000/4000 Router Series IP Multicast Configuration Guide

157
Device Interface IPv6 address Device Interface IPv6 address
Router H Eth1/1 4001::1/64 Source 1 - 2001::100/64
Eth1/2 3004::2
/
64 Source 2 - 3001::100/64
Router I Eth1/1 5001::1/64 Source 3 - 9001::100/64
Eth1/2 4001::2/64
Configuration procedure
1. Assign an IPv6 address and prefix length to each interface according to Figure 54. (Details not
shown.)
2. Enable OSPFv3 on all routers on the IPv6 PIM-SM network to make sure the network-layer on the
IPv6 PIM-SM network is interoperable and the routing information among the routers can be
dynamically updated. (Details not shown.)
3. Enable IPv6 multicast routing, MLD, and IPv6 PIM-SM:
# On Router A, enable IPv6 multicast routing globally, enable MLD on Ethernet 1/1, and enable
IPv6 PIM-SM on each interface.
<RouterA> system-view
[RouterA] ipv6 multicast routing
[RouterA-mrib6] quit
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] mld enable
[RouterA-Ethernet1/1] ipv6 pim sm
[RouterA-Ethernet1/1] quit
[RouterA] interface ethernet 1/2
[RouterA-Ethernet1/2] ipv6 pim sm
[RouterA-Ethernet1/2] quit
# Enable IPv6 multicast routing, MLD, and IPv6 PIM-SM on Router E and Router I in the same way
Router A is configured. (Details not shown.)
# On Router B, enable IPv6 multicast routing globally, and enable IPv6 PIM-SM on each interface.
<RouterB> system-view
[RouterB] ipv6 multicast routing
[RouterB-mrib6] quit
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] ipv6 pim sm
[RouterB-Ethernet1/1] quit
[RouterB] interface ethernet 1/2
[RouterB-Ethernet1/2] ipv6 pim sm
[RouterB-Ethernet1/2] quit
[RouterB] interface ethernet 1/3
[RouterB-Ethernet1/3] ipv6 pim sm
[RouterB-Ethernet1/3] quit
[RouterB] interface ethernet 1/4
[RouterB-Ethernet1/4] ipv6 pim sm
[RouterB-Ethernet1/4] quit
# Enable IPv6 multicast routing and IPv6 PIM-SM on Router C, Router D, Router F, Router G, and
Router H in the same way Router B is configured. (Details not shown.)
4. Configure IPv6 admin-scoped zone boundaries: