HP MSR2000/3000/4000 Router Series IP Multicast Configuration Guide
22
Ste
p
Command
Remarks
2. Enter IGMP-snooping view.
igmp-snooping N/A
3. Set the aging timer for dynamic
router ports globally.
router-aging-time interval The default setting is 260 seconds.
4. Set the global aging timer for
dynamic member ports globally.
host-aging-time interval The default setting is 260 seconds.
Setting the aging timers for the dynamic ports in a VLAN
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter VLAN view.
vlan vlan-id N/A
3. Set the aging timer for the
dynamic router ports in the
VLAN.
igmp-snooping router-aging-time
interval
The default setting is 260 seconds.
4. Set the aging timer for the
dynamic member ports in the
VLAN.
igmp-snooping host-aging-time
interval
The default setting is 260 seconds.
Configuring static ports
If all hosts attached to a port are interested in the multicast data addressed to a particular multicast group
or the multicast data that a particular multicast source sends to a particular group, you can configure the
port as a static member port for the specified multicast group or the specified multicast source and group.
You can also configure a port as a static router port, through which the switch can forward all the
multicast traffic it receives.
When you configure static ports, follow these guidelines:
• A static member port does not respond to queries from the IGMP querier. When you configure a
port as a static member port or cancel this configuration on the port, the port does not send
unsolicited IGMP reports or IGMP leave messages.
• Static member ports and static router ports never age out. To remove such a port, use the
corresponding undo command.
To configure static ports:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter Layer 2 Ethernet
interface view.
interface interface-type
interface-number
N/A
3. Configure the port as a static
member port.
igmp-snooping static-group
group-address [ source-ip
source-address ] vlan vlan-id
By default, a port is not a static
member port.
4. Configure the port as a static
router port.
igmp-snooping static-router-port
vlan vlan-id
By default, a port is not a static
router port.