HP MSR2000/3000/4000 Router Series Layer 2 - LAN Switching Command Reference
Table Of Contents
- Title Page
- Contents
- MAC address table commands
- Port isolation commands
- Spanning tree commands
- active region-configuration
- check region-configuration
- display stp
- display stp abnormal-port
- display stp bpdu-statistics
- display stp down-port
- display stp history
- display stp region-configuration
- display stp root
- display stp tc
- instance
- region-name
- reset stp
- revision-level
- stp bpdu-protection
- stp bridge-diameter
- stp compliance
- stp config-digest-snooping
- stp cost
- stp edged-port
- stp enable
- stp global config-digest-snooping
- stp global enable
- stp global mcheck
- stp loop-protection
- stp max-hops
- stp mcheck
- stp mode
- stp no-agreement-check
- stp pathcost-standard
- stp point-to-point
- stp port priority
- stp port-log
- stp priority
- stp region-configuration
- stp role-restriction
- stp root primary
- stp root secondary
- stp root-protection
- stp tc-protection
- stp tc-protection threshold
- stp tc-restriction
- stp timer forward-delay
- stp timer hello
- stp timer max-age
- stp timer-factor
- stp transmit-limit
- vlan-mapping modulo
- Loop detection commands
- VLAN commands
- LLDP commands
- display lldp local-information
- display lldp neighbor-information
- display lldp statistics
- display lldp status
- display lldp tlv-config
- lldp admin-status
- lldp check-change-interval
- lldp enable
- lldp encapsulation snap
- lldp fast-count
- lldp global enable
- lldp hold-multiplier
- lldp management-address-format string
- lldp max-credit
- lldp mode
- lldp notification med-topology-change enable
- lldp notification remote-change enable
- lldp timer fast-interval
- lldp timer notification-interval
- lldp timer reinit-delay
- lldp timer tx-interval
- lldp tlv-enable
- Support and other resources
- Index
28
reset stp
Use reset stp to clear the MSTP statistics information. The MSTP statistics information includes the numbers
of TCN BPDUs, configuration BPDUs, RST BPDUs, and MST BPDUs that are sent and received through the
specified ports.
Syntax
reset stp [ interface interface-list ]
Views
User view
Predefined user roles
network-admin
Parameters
interface interface-list: Clears the MSTP statistics information of the ports that are specified in the format
of interface-list = { interface-type interface-number [ to interface-type interface-number ] }&<1-10>, where
&<1-10> indicates that you can specify up to 10 ports or port ranges. If you don't specify this option, this
command clears the spanning tree-related statistics information on all ports.
Examples
# Clear the spanning tree-related statistics on ports Ethernet 2/1 through Ethernet 2/3.
<Sysname> reset stp interface ethernet 2/1 to ethernet 2/3
Related commands
display stp
revision-level
Use revision-level to configure the MSTP revision level.
Use undo revision-level to restore the default MSTP revision level.
Syntax
revision-level level
undo revision-level
Default
The MSTP revision level is 0.
Views
MST region view
Predefined user roles
network-admin
Parameters
level: Specifies an MSTP revision level in the range of 0 to 65535.