HP MSR2000/3000/4000 Router Series Layer 2 - LAN Switching Command Reference

42
undo stp [ instance instance-list ] port priority
Default
The port priority is 128.
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Parameters
instance instance-list: Sets the priority of the ports in the MSTIs that are specified by an instance list, in the
format of instance-list = { instance-id [ to instance-id ] }&<1-10>, where &<1-10> indicates that you can
specify up to 10 instances or instance ranges. The value range for the instance-id argument is 0 to 4094,
and the value 0 represents the CIST.
priority: Specifies the port priority in the range of 0 to 240 in increments of 16 (as in 0, 16, 32).
Usage guidelines
The smaller the value, the higher the port priority. If all ports on your device use the same priority value,
the port priority depends on the port index. The smaller the index, the higher the priority.
When the setting is configured in Layer 2 Ethernet interface view, it takes effect on only that interface.
Examples
# In MSTP mode, set the priority of port Ethernet 2/3 to 16 in MSTI 2.
<Sysname> system-view
[Sysname] interface ethernet 2/3
[Sysname-Ethernet2/3] stp instance 2 port priority 16
Related commands
display stp
stp port-log
Use stp port-log to enable outputting port state transition information for the specified MSTI or for all
MSTIs.
Use undo stp port-log to disable outputting port state transition information for the specified MSTI or for
all MSTIs.
Syntax
stp port-log { all | instance instance-list }
undo stp port-log { all | instance instance-list }
Default
This function is disabled.
Views
System view
Predefined user roles
network-admin