HP MSR2000/3000/4000 Router Series Layer 2 - WAN Command Reference

148
Parameters
seconds: Specifies the interval between call attempts, in the range of 1 to 604800 seconds.
Usage guidelines
This command takes effect only when the autodial keyword is configured in the dialer number or dialer
route command. It allows DDR to automatically dial at certain intervals to set up a connection. In the
auto-dial approach, dial attempts to set up a connection are not traffic triggered. Once a connection is
set up, it will not disconnect for idle-timeout. The use of auto-dial thus voids the dialer timer idle
command.
Examples
# Set the auto-dial interval of DDR to 60 seconds on interface Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] dialer timer autodial 60
Related commands
dialer route
dialer timer compete
Use dialer timer compete to set the compete-idle timer.
Use undo dialer timer compete to restore the default.
Syntax
dialer timer compete seconds
undo dialer timer compete
Default
The compete-idle timer is 20 seconds.
Views
Dialup interface (physical or dialer interface) view
Predefined user roles
network-admin
Parameters
seconds: Idle interval when contention occurs, in the range of 0 to 65535 seconds.
Usage guidelines
If all the channels are unavailable when DDR originates a new call, contention occurs.
An idle-timeout timer starts upon setup of a link. If a call to another destination address is placed at the
same time, contention occurs. DDR starts a compete-idle timer to replace the idle-timeout timer for the link.
When the idle time of the link reaches the setting of this compete-idle timer, the link disconnects.
Examples
# Set the compete-idle timer to 10 seconds on interface Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0