HP MSR2000/3000/4000 Router Series Layer 2 - WAN Command Reference

155
Dialer1
Current state: UP
Line protocol state: UP (spoofing)
Description: Dialer1 Interface
Bandwidth: 64kbps
Maximum Transmit Unit: 1500
Hold timer: 10 seconds
Internet protocol processing: disabled
Link layer protocol: PPP
LCP: initial
Physical: Dialer, baudrate: 64000 bps
Output queue: (Urgent queuing: Length) 50
Output queue: (Protocol queuing: Length) 500
Output queue: (FIFO queuing: Length) 75
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 dropped
Output: 0 packets, 0 bytes, 0 dropped
# Display brief information about interface Dialer 1.
<Sysname> display interface dialer 1 brief
Brief information on interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface Link Protocol Main IP Description
Dia1 UP UP(s) --
# Display brief information about all dialer interfaces in physically Down state.
<Sysname> display interface dialer brief down
Brief information on interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Interface Link Cause
Dia1 ADM Administratively
Table 24 Command output
Field Descri
p
tion
Dialer1
Current state
Physical state of the dialer interface:
• UP—The dialer interface is physically up.
• DOWN (Administratively)—The dialer interface was shut down with the
shutdown command. To re-enable it, you must use the undo shutdown
command on it.
Line protocol state Data link layer protocol state of the dialer interface: UP or DOWN.
Description Interface description.
Bandwidth Intended bandwidth of the interface.
Maximum Transmit Unit MTU of the dialer interface.
Internet protocol processing Network layer protocol state of the dialer interface.