HP MSR2000/3000/4000 Router Series Layer 2 - WAN Command Reference

17
Field Descri
p
tion
Last 300 seconds input rate: 0
bytes/sec, 0 packets/sec
Last 300 seconds output rate: 0
bytes/sec, 0 packets/sec
Average rate of input packets and output packets in the last 300
seconds.
Input: 0 packets, 0 bytes, 0 droped
Total number of inbound packets of the interface (in the number of
packets and in bytes), and the number of dropped incoming packets.
Output: 0 packets, 0 bytes, 0 droped
Total number of outbound packets of the interface (in the number of
packets and in bytes), and the number of dropped outgoing packets.
Brief information on interface(s) under
route mode
Brief information about Layer 3 interfaces.
Link: ADM - administratively down;
Stby - standby
Link status:
• ADM—The interface has been administratively shut down. To
recover its physical state, execute the undo shutdown command.
• Stby—The interface is operating as a backup interface. To see the
primary interface, use the display standby state command in
High Availability Command Reference.
Protocol: (s) - spoofing
Indicates the network layer protocol state of an interface is UP, but its
link is an on-demand link or is not present.
Interface Abbreviated interface name.
Link
Physical link state of the interface:
• UP—The link is up.
• DOWN—The link is down.
• ADM—The link has been administratively shut down. To recover
its physical state, use the undo shutdown command.
Protocol Line protocol state of the interface: UP or DOWN.
Main IP Primary IP address of the interface.
Description
Interface description configured by using the description command.
Without the description keyword, the display interface brief
command displays at most 27 characters of the description.
Cause
Causes for the physical state of the interface to be Down:
• Not connected—No physical connection exists (possibly because
the network cable is disconnected or faulty).
• Administratively—The port was shut down with the shutdown
command. To restore the physical state of the interface, use the
undo shutdown command.
Related commands
reset counters interface mp-group
display interface virtual-template
Use display interface virtual-template to display information about VT interfaces.
Syntax
display interface [ virtual-template ] [ brief [ down | description ] ]