4000 Router Series Layer 2 - WAN Command Reference

Examples

# Set the protocol mode for interface BRI 2/0 to the network side mode.

<Sysname> system-view

[Sysname] interface bri 2/0

[Sysname-Bri2/0] isdn protocol-mode network

isdn protocol-type

Use isdn protocol-type to set the ISDN protocol to be run on an ISDN interface.

Use undo isdn protocol-type to restore the default.

Syntax

isdn protocol-type protocol

undo isdn protocol-type

Default

Both BRI and PRI interfaces run ISDN protocol DSS1.

Views

ISDN interface view

Predefined user roles

network-admin

Parameters

protocol: Specifies the ISDN protocol, which can be 5ess, ansi, at&t, dss1, etsi, ni, ni2, ntt, or qsig.

Usage guidelines

Configure this command only if no call exists on an ISDN interface.

You can configure:

• ANSI on BRI and CT1/PRI interfaces.

• AT&T on CT1/PRIs.

• 5ESS on CT1/PRIs.

• DSS1 on BRI, CE1/PRI, and CT1/PRI interfaces.

• ETSI on BRI, CE1/PRI, and CT1/PRI interfaces.

• NI on BRIs.

• NI2 on CT1/PRIs.

• QSIG on CE1/PRI and CT1/PRI interfaces.

• NTT on BRI and CT1/PRI interfaces.

• ANSI, AT&T, ETSI, NI, and NTT only on an ISDN interface that operates in user side mode.

Examples

# Set ISDN ETSI to be run on BRI 2/0.

<Sysname> system-view

[Sysname] interface bri 2/0

[Sysname-Bri2/0] isdn protocol-type etsi