HP MSR2000/3000/4000 Router Series Layer 2 - WAN Configuration Guide

101
Complete these tasks to configure B-DDR for on-demand calling:
Task Remarks
Configuring the sending end for B-DDR Required.
Configuring the receiving end for B-DDR Required.
Configuring the sending end for B-DDR
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a dialer interface and
enter its view.
interface dialer number N/A
3. Enable B-DDR on the interface.
dialer bundle enable By default, B-DDR is disabled.
4. Configure the dial string and
destination address for calling
a remote end.
dialer number dial-number N/A
5. Return to system view.
quit N/A
6. Enter physical interface view.
interface interface-type
interface-number
N/A
7. Assign the physical interface
to the specified dialer bundle.
dialer bundle-member number
[ priority priority ]
By default, a physical interface
does not belong to any dialer
bundle.
Make sure the number arguments
in the interface dialer and dialer
bundle-member commands use
the same value.
Configuring the receiving end for B-DDR
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Create a dialer interface and
enter its view.
interface dialer number N/A
3. Enable B-DDR on the interface.
dialer bundle enable By default, B-DDR is disabled.