HP MSR2000/3000/4000 Router Series Layer 2 - WAN Configuration Guide

105
Configuring the client of ISDN caller identification callback
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter dialup interface
(physical or dialer interface)
view.
interface interface-type
interface-number
N/A
3. Configure one or multiple
destination addresses and
dial strings.
dialer route protocol
next-hop-address [ mask
network-mask-length ] [ vpn-instance
vpn-instance-name ] [ dial-number
[ autodial | interface interface-type
interface-number ] * ] [ broadcast |
user hostname ] *
By default, no dial strings and
destination addresses are
configured.
To place a call to a single remote
end, you can also use the dialer
number dial-number command.
4. (Optional.) Set the interval for
DDR to make the next call
attempt.
dialer timer enable seconds
The default is 5 seconds.
To leave enough time for a server
to call back, set the interval for
DDR to make the next call attempt
on the client at least 10 seconds
longer than that of the server. HP
recommends that you set the
interval on the server to 5 seconds
(the default) and that on the client
to 15 seconds.
Configuring the server of ISDN caller identification callback
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter dialup interface
(physical or dialer interface)
view.
interface interface-type interface-number N/A
3. Configure the interface to
accept incoming calls from
the specified calling number
or to call back.
dialer call-in remote-number [ callback ]
By default, callback is not
performed.
4. Configure one or multiple
destination addresses and
dial strings.
dialer route protocol next-hop-address
[ mask network-mask-length ]
[ vpn-instance vpn-instance-name ]
[ dial-number [ autodial | interface
interface-type interface-number ] * ]
[ broadcast | user hostname ] *
By default, no dial strings
and destination addresses
are configured.
To place a call to a single
remote end, you can also
use the dialer number
dial-number command.
The dial-number argument
in the dialer route or dialer
number command must be
configured as the same
value as the remote-number
argument in the dialer
call-in command.