HP MSR2000/3000/4000 Router Series Layer 2 - WAN Configuration Guide

113
Ste
p
Command Remarks
8. Configure the link
idle-timeout timer.
dialer timer idle seconds [ in | in-out ]
The default setting is 120
seconds.
When this timer is set to 0
seconds, the PPPoE session
operates in permanent mode.
Otherwise, the PPPoE session
operates in on-demand mode.
9. Set the auto-dial interval.
dialer timer autodial seconds
The default setting is 300
seconds.
In permanent or diagnostic
mode, DDR starts the auto-dial
timer after the link is
disconnected and originates a
new call when the auto-dial
timer expires.
HP recommends that you set a
shorter auto-dial interval for
DDR to soon originate a new
call.
10. Configure the DDR
application to operate in
diagnostic mode.
dialer diagnose [ interval seconds ]
By default, the DDR application
operates in non-diagnostic
mode.
When DDR operates in
diagnostic mode, the link idle
time is ignored.
11. Return to system view.
quit N/A
12. Enter Layer 3 Ethernet
interface/subinterface, Layer
3 virtual Ethernet
interface/subinterface,
VLAN interface, or WLAN
Ethernet interface view.
interface interface-type
interface-number
N/A
13. Create a PPPoE session and
specify a dialer bundle for
the session.
pppoe-client dial-bundle-number
number [ no-hostuniq ]
By default, no PPPoE sessions
are created.
The number argument in this
command must use the same
value as the configured dialer
interface number.
Displaying and maintaining DDR
Task Command Remarks
Display DDR information for a
specified dialup interface or all
dialup interfaces.
display dialer [ interface
interface-type interface-number ]
Available in any view.