4000 Router Series Layer 2 - WAN Configuration Guide

142

PPPoE client diagnostic mode configuration

example

Network requirements

As shown in Figure 54, configure Router A as a PPPoE server and Router B as a PPPoE client operating

in diagnostic mode, and set the diagnostic interval to 200 seconds.

Figure 54 Network diagram

Configuration procedure

1. Configure Router A as the PPPoE server.

# Configure virtual template parameters.

<RouterA> system-view

[RouterA] interface virtual-template 1

[RouterA-Virtual-Template1] ip address 1.1.1.1 255.0.0.0

[RouterA-Virtual-Template1] remote address 1.1.1.2

[RouterA-Virtual-Template1] quit

# Configure the PPPoE server.

[RouterA] interface ethernet 1/1

[RouterA-Ethernet1/1] pppoe-server bind virtual-template 1

2. Configure Router B as the PPPoE client.

# Configure parameters for interface Dialer 1.

<RouterB> system-view

[RouterB] dialer-group 1 rule ip permit

[RouterB] interface dialer 1

[RouterB-Dialer1] dialer bundle enable

[RouterB-Dialer1] dialer-group 1

[RouterB-Dialer1] ip address ppp-negotiate

[RouterB-Dialer1] quit

# Configure the PPPoE client.

[RouterB] interface ethernet 1/1

[RouterB-Ethernet1/1] pppoe-client dial-bundle-number 1

[RouterB-Ethernet1/1] quit

# Configure the PPPoE client to operate in diagnostic mode, and set the diagnostic interval to 200

seconds.

[RouterB] interface dialer 1

[RouterB-Dialer1] dialer diagnose interval 200

# Set the auto-dial interval to 10 seconds on Dialer 1.