HP MSR2000/3000/4000 Router Series Layer 2 - WAN Configuration Guide

11
Ste
p
Command Remarks
6. Set the expected bandwidth of
the VT interface.
bandwidth bandwidth-value
By default, the expected
bandwidth (in kbps) is the
interface baud rate divided
by 1000.
7. (Optional.) Specify a card to
forward traffic for the VA
interfaces of the VT interface.
service slot slot-number
By default, no card is
specified.
Only the MSR4000 routers
support this function.
8. (Optional.) Restore the default
settings for the VT interface.
default N/A
Configuring MP through an MP-group interface
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an MP-group interface
and enter its view.
interface mp-group mp-number
If the MP-group interface already
exists, you directly enter its view.
3. (Optional.) Set the maximum
number of links allowed in an
MP bundle.
ppp mp max-bind max-bind-num
The default setting is 16.
For this command to take effect on
an MP bundle, you must re-enable
the MP-group interface by
executing the shutdown command
and then the undo shutdown
command.
4. Set the minimum MP packet
size for fragmentation.
ppp mp min-fragment size The default setting is 128 bytes.
5. Configure the MP sort buffer
size factor.
ppp mp sort-buffer-size size The default setting is 1.
6. (Optional.) Start the timer for
waiting for the expected
fragment.
ppp mp timer lost-fragment
seconds
By default, the timer is not started.
7. (Optional.) Disable MP
fragmentation.
ppp mp fragment disable
By default, MP fragmentation is
enabled.
After you configure this command
on an interface, the settings
configured with the ppp mp lfi
enable and ppp mp min-fragment
commands become invalid on the
interface.
8. (Optional.) Set the interface
description.
description text
Optional.
The default setting is interface
name Interface, for example,
MP-group3 Interface.
9. Set the polling interval.
timer-hold seconds The default setting is 10 seconds.