HP MSR2000/3000/4000 Router Series Layer 2 - WAN Configuration Guide

31
Resetting a PPPoE session
After you reset a PPPoE session in permanent mode, the device establishes a new PPPoE session when the
autodial timer expires.
After you reset a PPPoE session in on-demand mode, the device establishes a new PPPoE session when
there is a demand for data transmission.
To reset a PPPoE session:
Ste
p
Command Remarks
1. Reset a PPPoE session.
reset pppoe-client { all |
dial-bundle-number number }
Available in user view.
Displaying and maintaining PPPoE
Execute display commands in any view and reset commands in user view.
Task Command
Display summary information about a PPPoE
session.
display pppoe-client session summary [ dial-bundle-number
number ]
Display the protocol packet statistics for a PPPoE
session.
display pppoe-server session packet [ dial-bundle-number
number ]
Clear the protocol packet statistics for a PPPoE
session.
reset pppoe-server session packet [ dial-bundle-number
number ]
PPPoE client configuration example
Network requirements
As shown in Figure 13, configure Router A as a PPPoE server and Router B as a PPPoE client.
Figure 13 Network diagram
Configuration procedure
1. Configure Router B as the PPPoE client:
# Create dialer access group 1 and configure a dial access control rule for it.
<RouterB> system-view