4000 Router Series Layer 2 - WAN Configuration Guide

[RouterB] dialer-group 1 rule ip permit

# Enable bundle DDR on interface Dialer 1.

[RouterB] interface dialer 1

[RouterB-Dialer1] dialer bundle enable

# Associate interface Dialer 1 with dialer access group 1.

[RouterB-Dialer1] dialer-group 1

[RouterB-Dialer1] quit

# Configure a PPPoE session that corresponds to dialer bundle 1 (dialer bundle 1 corresponds to

interface Dialer 1).

[RouterB] interface ethernet 1/1

[RouterB-Ethernet1/1] pppoe-client dial-bundle-number 1

[RouterB-Ethernet1/1] quit

# Configure the PPPoE session to operate in permanent mode.

[RouterB] interface dialer 1

[RouterB-Dialer1] dialer timer idle 0

# Set the DDR auto-dial interval to 60 seconds.

[RouterB-Dialer1] dialer timer autodial 60

2. Verify the configurations by displaying summary information about the PPPoE session established

between Router B and Router A (PPPoE server).

[RouterB-Dialer1] display pppoe-client session summary

Bundle ID Interface VA RemoteMAC LocalMAC State

1 1 Eth1/1 VA0 00e0-1400-4300 00e0-1500-4100 SESSION