HP MSR2000/3000/4000 Router Series Layer 2 - WAN Configuration Guide
68
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter ISDN BRI or PRI
interface view.
interface interface-type
interface-number
N/A
3. Configure ISDN B channel
local management.
isdn bch-local-manage
[ exclusive ]
By default, the ISDN B channel local
management is not enabled, and the ISDN B
channel is managed by the PBX.
Exclusive local management mode for ISDN B
channels is applied to the network side for the
device. If the device serves as the user side
connected to the PBX, and the B channel
indicated by the PBX is inconsistent with that
required by the local end, the call fails.
4. Set a B channel selection
method.
isdn bch-select-way
{ ascending | descending }
By default, when operating in B channel local
management mode, the device selects B
channels in ascending order. Executing this
command does not take effect when the PBX
manages ISDN B channels.
Configuring a permitted calling number for incoming calls
If a setup message does not include a calling number or the calling number included is different from the
number that is configured through this task, the call fails.
To configure a permitted calling number for incoming calls:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter ISDN BRI or PRI interface
view.
interface interface-type interface-number N/A
3. Configure a permitted calling
number for incoming calls.
isdn caller-number caller-number
By default, ISDN accepts
all incoming calls without
checking the calling
numbers in setup
messages.
Configuring the calling number of outgoing calls
After the calling party sends the calling number to the called party, the called party can see the calling
number through the display isdn call-info command. If the called party has configured the isdn
caller-number command, it will check the calling number sent from the calling party.
After you perform this task, the calling number can be sent to the called party only if the PBX includes the
calling number.
To configure an interface to send the calling number during an outgoing call: