4000 Router Series Layer 2 - WAN Configuration Guide

ManualsBrandsHP ManualsNetwork HardwareHP MSR3024 TAA-compliant AC Router

Ste

Command

Remarks

7. Specify a network connection

method on a WCDMA

network.

mode wcdma { gsm-only |

gsm-precedence | wcdma-only |

wcdma-precedence }

This command applies to only 3G

modems accessing a WCDMA

network.

The default setting depends on the

modem model.

Creating a parameter template

A parameter template is used to configure the access point with which a 3G modem associates and the

authentication mode in which the service provider authenticates the 3G modem.

To create a parameter template:

Ste

Command

Remarks

1. Enter system view.

system-view N/A

2. Enter cellular interface view.

controller cellular interface-number

N/A

3. Create a parameter template.

profile create profile-number

{ dynamic | static apn }

authentication-mode { none |

{ chap | pap } user username

[ password password ] }

If you specify none, no

authentication is performed. If you

specify chap or pap, configure the

username and password

according to the requirement of the

service provider.

The default setting depends on the

modem model.

4. Delete a parameter template.

profile delete profile-number N/A

Configuring PIN authentication

Each SIM/UIM card has a PIN for authentication to prevent unauthorized users.

With PIN authentication enabled, a user needs to enter the PIN for authentication after:

• Installing a 3G modem.

• Rebooting the device where a USB 3G modem is attached.

• Executing the modem reboot command to reboot a 3G modem.

• Hot swapping a USB 3G modem.

• Cold booting the device where a SIC-3G modem is installed.

In PIN authentication, if you cannot enter a correct PIN in specific attempts (depending on the 3G

modem model), you need a PUK to unlock the card.

To configure PIN authentication:

Ste

Command

Remarks

1. Enter system view.

system-view N/A

2. Enter cellular interface view.

controller cellular interface-number

N/A