4000 Router Series Layer 3 - IP Routing Command Reference

174

Predefined user roles

network-admin

Parameters

interface-type interface-number: Specifies an interface by its type and number.

all: Specifies all interfaces.

Usage guidelines

A disabled interface is a passive interface that cannot receive or send any hello packets.

To disable a network from receiving and sending OSPF routes, issue the command on the interface

connected to the network.

Examples

# Disable interface Ethernet 1/1 from receiving and sending OSPF packets.

<Sysname> system-view

[Sysname] ospf 100

[Sysname-ospf-100] silent-interface ethernet1/1

snmp-agent trap enable ospf

Use snmp-agent trap enable ospf to enable SNMP notifications for OSPF.

Use undo snmp-agent trap enable ospf to disable the feature.

Syntax

snmp-agent trap enable ospf [ authentication-failure | bad-packet | config-error |

lsdb-approaching-overflow | lsdb-overflow | neighbor-state-change | nssatranslator-status-change |

virtgrhelper-status-change | virtif-state-change | virtneighbor-state-change ] *

undo snmp-agent trap enable ospf [ authentication-failure | bad-packet | config-error |

lsdb-approaching-overflow | lsdb-overflow | neighbor-state-change | nssatranslator-status-change |

virtgrhelper-status-change | virtif-state-change | virtneighbor-state-change ] *

Default

SNMP notifications for OSPF is enabled.

Views

System view

Predefined user roles

network-admin

Parameters

authentication-failure: Specifies notifications about authentication failures on an interface.

bad-packet: Specifies notifications about error messages received on an interface.

config-error: Specifies notifications about error configuration of an interface.