HP MSR2000/3000/4000 Router Series Layer 3 - IP Routing Command Reference

340
network short-cut
Use network short-cut to increase the preference for a received EBGP route. This EBGP route is called
shortcut route.
Use undo network short-cut to cancel the configuration.
Syntax
In BGP IPv4 unicast address family view/BGP-VPN IPv4 unicast address family view:
network ip-address [ mask | mask-length ] short-cut
undo network ip-address [ mask | mask-length ] short-cut
In BGP IPv6 unicast address family view/BGP-VPN IPv6 unicast address family view:
network ipv6-address prefix-length short-cut
undo network ipv6-address prefix-length short-cut
Default
A received EBGP route has a preference of 255.
Views
BGP IPv4 unicast address family view, BGP-VPN IPv4 unicast address family view, BGP IPv6 unicast
address family view, BGP-VPN IPv6 unicast address family view
Predefined user roles
network-admin
Parameters
ip-address: Specifies an IPv4 network address. If the mask or mask-length is not specified, natural mask
is used.
mask: Specifies a mask of the network address in dotted decimal notation.
mask-length: Specifies a mask length in the range of 0 to 32.
ipv6-address: Specifies an IPv6 network address.
prefix-length: Specifies a prefix length in the range of 0 to 128.
Usage guidelines
Different routing protocols might find different routes to the same destination. However, not all of those
routes are optimal. For route selection, routing protocols, direct routes, and static routes are assigned
different preferences. The route with the highest preference is preferred.
By default, the preference of an EBGP route is lower than a local route. If a device has an EBGP route and
a local route to reach the same destination, the device does not select the EBGP route. You can use the
network shortcut command to configure the EBGP route to have the same preference as the local route
so the EBGP route is more likely to become the optimal route.
You can use the preference command to modify the preferences for external and local BGP routes.
Examples
# In BGP IPv4 unicast address family view, increase the preference of EBGP route 10.0.0.0/16.
<Sysname> system-view
[Sysname] bgp 100