HP MSR2000/3000/4000 Router Series Layer 3 - IP Routing Command Reference

382
Predefined user roles
network-admin
Parameters
group-name: Specifies a peer group by its name, a case-sensitive string of 1 to 47 characters. The peer
group must have been created.
ip-address: Specifies a peer by its IP address. The peer must have been created.
ipv6-address: Specifies a peer by its IPv6 address. The peer must have been created.
route-policy-name: Specifies a routing policy by its name, a case-sensitive string of 1 to 63 characters.
export: Applies the routing policy to routes outgoing to the peer or peer group.
import: Applies the routing policy to routes incoming from the peer or peer group.
Usage guidelines
The specified routing policy must have been configured with the route-policy command in system view.
Otherwise, all routes can pass the routing policy.
The if-match interface command, if configured for the referenced routing policy, does not take effect for
routes.
Examples
# In BGP IPv4 unicast address family view, apply routing policy test-policy to routes outgoing to the peer
group test.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] address-family ipv4 unicast
[Sysname-bgp-ipv4] peer test route-policy test-policy export
# In BGP-VPN IPv6 unicast address family view, apply the routing policy test-policy to routes outgoing to
the peer group test.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ip vpn-instance vpn1
[Sysname-bgp-vpn1] address-family ipv6 unicast
[Sysname-bgp-ipv6-vpn1] peer test route-policy test-policy export
Related commands
• filter-policy export
• filter-policy import
• peer as-path-acl
• peer filter-policy
• peer prefix-list
• route-policy
peer route-update-interval
Use peer route-update-interval to specify an interval for sending the same update to a peer or peer
group.