HP MSR2000/3000/4000 Router Series Layer 3 - IP Routing Command Reference

448
prefix-length: Specifies the prefix length of the destination IPv6 address of the summary route, in the
range of 0 to 128. It indicates the number of consecutive 1s of the prefix, which defines the network ID.
Usage guidelines
Networks falling into the summary network will not be advertised. The cost of the summary route is the
lowest cost among summarized routes.
Examples
# Assign an IPv6 address with the 64-bit prefix to Ethernet 1/1 and configure a summary with the 35-bit
prefix.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] ipv6 address 2001:200::3EFF:FE11:6770/64
[Sysname-Ethernet1/1] ripng summary-address 2001:200:: 35
timers
Use timers to configure RIPng timers.
Use undo timers to restore the default.
Syntax
timers { garbage-collect garbage-collect-value | suppress suppress-value | timeout timeout-value |
update update-value } *
undo timers { garbage-collect | suppress | timeout | update } *
Default
The garbage-collect timer is 120 seconds, the suppress timer is 120 seconds, the timeout timer is 180
seconds, and the update timer is 30 seconds.
Views
RIPng view
Predefines user roles
network-admin
Parameters
garbage-collect-value: Sets the garbage-collect timer in the range of 1 to 86400 seconds.
suppress-value: Sets the suppress timer in the range of 0 to 86400 seconds.
timeout-value: Sets the timeout timer in the range of 1 to 86400 seconds.
update-value: Sets the update timer in the range of 1 to 86400 seconds.
Usage guidelines
RIPng has the following timers:
• Update timer—Interval between update messages.
• Timeout timer—Route aging time. If no update for a route is received before the timer expires, RIPng
sets the metric of the route to 16.
• Suppress timer—How long a RIPng route stays in suppressed state. When the metric of a route
becomes 16, the route enters the suppressed state. If RIPng receives an update for the route from the