HP MSR2000/3000/4000 Router Series Layer 3 - IP Routing Command Reference

502
Syntax
ospfv3 timer retransmit seconds [ instance instance-id ]
undo ospfv3 timer retransmit [ instance instance-id ]
Default
The interval defaults to 5 seconds.
Views
Interface view
Predefined user roles
network-admin
Parameters
seconds: Specifies the LSA retransmission interval in the range of 1 to 3600 seconds.
instance-id: Specifies an instance by its ID in the range of 0 to 255, The default is 0.
Usage guidelines
After the device sends an LSA to its neighbor, it waits for an acknowledgement. If the device receives no
acknowledgement after the LSA retransmission interval elapses, it will retransmit the LSA.
The LSA retransmission interval should not be too small for avoidance of unnecessary retransmissions.
Examples
# Configure the LSA retransmission interval on Ethernet 1/1 in instance 1 as 12 seconds.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] ospfv3 timer retransmit 12 instance 1
ospfv3 trans-delay
Use ospfv3 trans-delay to configure the transmission delay for an interface.
Use undo ospfv3 trans-delay to restore the default.
Syntax
ospfv3 trans-delay seconds [ instance instance-id ]
undo ospfv3 trans-delay [ instance instance-id ]
Default
The transmission delay is 1 second.
Views
Interface view
Predefined user roles
network-admin
Parameters
seconds: Specifies the transmission delay in the range of 1 to 3600 seconds.
instance-id: Specifies an instance by its ID in the range of 0 to 255. The default is 0.