4000 Router Series Layer 3 - IP Routing Command Reference

536

undo apply next-hop [ [ vpn-instance vpn-instance-name | inbound-vpn ] ipv6-address&<1-n> ]

Default

No next hop is set.

Views

IPv6 policy node view

Predefined user roles

network-admin

Parameters

vpn-instance vpn-instance-name: Specifies an MPLS L3VPN instance by its name, a case-sensitive string

of 1 to 31 characters. The specified VPN must already exist.

inbound-vpn: Specifies the VPN instance where the inbound interface belongs.

ipv6-address: Specifies the next-hop IPv6 address. Without the vpn-instance vpn-instance-name option

or the inbound-vpn keyword, the default next hop belongs to the public network.

direct: Specifies that the next hop must be directly connected to take effect.

track track-entry-number: Specifies a track entry by its name in the range of 1 to 1024.

&<1-n>: Indicates that the argument before it can be entered up to n times. The value of n depends on

the device model.

Usage guidelines

You can specify multiple next hops for backup or load sharing by executing this command once or

multiple times.

You can specify up to m next hops for a node. The value of m depends on the device model.

With a next hop specified, the undo apply next-hop command removes the next hop.

Without any next hop specified, the undo apply next-hop command removes all next hops.

Examples

# Set a directly-connected next hop of 1::1.

<Sysname> system-view

[Sysname] ipv6 policy-based-route aa permit node 11

[Sysname-pbr6-aa-11] apply next-hop 1::1

Related commands

apply loadshare next-hop

apply output-interface

Use apply output-interface to set an output interface.

Use undo apply output-interface to remove the configuration.

Syntax

apply output-interface { interface-type interface-number [ track track-entry-number ] }&<1-n>

undo apply output-interface [ { interface-type interface-number }&<1-n> ]