HP MSR2000/3000/4000 Router Series Layer 3 - IP Routing Command Reference

74
Predefined user roles
network-admin
Parameters
process-id: Specifies a RIP process by its ID in the range of 1 to 65535.
exclude-subip: Excludes secondary IP addresses from being enabled with RIP. Without this keyword, RIP
is also enabled on secondary IP addresses of a RIP-enabled interface.
Usage guidelines
The rip enable command has a higher priority than the network command.
Examples
# Enable RIP process 100 on Ethernet 1/1.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] rip 100 enable
Related commands
network
rip input
Use rip input to enable an interface to receive RIP messages.
Use undo rip input to disable an interface from receiving RIP messages.
Syntax
rip input
undo rip input
Default
An interface is enabled to receive RIP messages.
Views
Interface view
Predefined user roles
network-admin
Examples
# Disable Ethernet 1/1 from receiving RIP messages.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] undo rip input
rip max-packet-length
Use rip max-packet-length to set the maximum length of RIP packets.
Use undo rip max-packet-length to restore the default.