HP MSR2000/3000/4000 Router Series Layer 3 - IP Routing Configuration Guide

403
Ste
p
Command Remarks
17. Set a tag value for RIP, OSPF,
and IS-IS route.
apply tag value
By default, no tag value is set for RIP,
OSPF, and IS-IS routes.
18. Set a backup link for fast
reroute (FRR).
apply fast-reroute
backup-interface interface-type
interface-number
[ backup-nexthop ip-address ]
By default, no backup link is set for
FRR.
Configuring a continue clause
Follow these guidelines when you configure a continue clause:
• If you configure the same type of apply clauses that set different values on nodes that are combined
by the continue clause, and the apply clauses are not configured with the additive keyword, the
apply clause configured on the last matching node takes effect. If the apply clauses are configured
with the additive keyword (including the apply as-path clauses without the replace keyword, the
apply cost clauses with the + or - keyword, the apply community clauses with the additive keyword,
and the apply extcommunity clauses with the additive keyword), all the apply clauses configured
on the matching nodes take effect.
• If you configure the apply community clause for multiple nodes that are combined by the continue
clause, the apply comm-list delete clause configured on the current node cannot delete the
community attributes set by preceding nodes.
To configure a continue clause:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter routing policy node view.
route-policy route-policy-name
{ deny | permit } node node-number
N/A
3. Specify the next node to be
matched.
continue [ node-number ]
By default, no continue clause is
configured.
The specified next node must
have a larger number than the
current node.
Displaying and maintaining the routing policy
Execute display commands in any view and reset commands in user view.
Task Command
Display BGP AS path list information. display ip as-path [ as-path-number ]
Display BGP community list information.
display ip community-list [ basic-community-list-number |
adv-community-list-number | comm-list-name ]
Display BGP extended community list
information.
display ip extcommunity-list [ ext-comm-list-number ]
Display IPv4 prefix list statistics. display ip prefix-list [ prefix-list-name ]