HP MSR2000/3000/4000 Router Series Layer 3 - IP Services Command Reference

127
ICMP-ERROR : Enabled
RTSP : Enabled
SIP : Disabled
TFTP : Enabled
The output shows all NAT configuration information. Table 26 describes only the fields for the output of
the nat hairpin enable, nat mapping-behavior, and nat alg commands.
Table 26 Command output
Field Descri
p
tion
NAT address group information
Information about the NAT address group. See Table 27 for
output
description.
NAT server group information
Information about the internal NAT server group. See Table 35 fo
r
output description.
NAT inbound information:
Inbound dynamic NAT configuration. See Table 30 fo
r output
description.
NAT outbound information
Outbound dynamic NAT configuration. See Table 33 for out
put
description.
NAT internal server information NAT Server configuration. See Table 34 for output description.
Static NAT mappings Static NAT mappings. See Table 37 for output description.
NAT DNS mappings NAT with DNS mappings. See Table 28 for output description.
NAT logging NAT logging configuration. See Table 31 for output description.
NAT hairpinning NAT hairpin configuration.
There are n interfaces enabled NAT
hairpinning function
Specifies the number of interfaces with NAT hairpin enabled.
Interface NAT hairpin-enabled interfaces.
NAT mapping behavior
Mapping behavior mode of PAT: Endpoint-Independent or Address
and Port-Dependent.
ACL ACL number. If no ACL is used for NAT, this field displays hyphens (---).
NAT ALG NAT with ALG configuration for different protocols.
display nat address-group
Use display nat address-group to display NAT address group information.
Syntax
display nat address-group [ group-number ]
Views
Any view
Predefined user roles
network-admin
network-operator