HP MSR2000/3000/4000 Router Series Layer 3 - IP Services Command Reference

317
destination
Use destination to specify the destination address for a tunnel interface.
Use undo destination to remove the configured tunnel destination address.
Syntax
destination { ip-address | ipv6-address }
undo destination
Default
No tunnel destination address is configured.
Views
Tunnel interface view
Predefined user roles
network-admin
Parameters
ip-address: Specifies the tunnel destination IPv4 address.
ipv6-address: Specifies the tunnel destination IPv6 address.
Usage guidelines
For a manual tunnel interface, you must configure the destination address. For an automatic tunnel
interface, you do not need to configure the destination address.
The tunnel destination address must be the address of the receiving interface on the tunnel peer. It is used
as the destination address of tunneled packets.
The destination address of the local tunnel interface must be the source address of the peer tunnel
interface, and vice versa.
Examples
# The interface Ethernet 1/1 of Sysname 1 uses the IP address 193.101.1.1 and the interface Ethernet 1/1
of Sysname 2 uses the IP address 192.100.1.1. Configure the source address 193.101.1.1 and destination
address 192.100.1.1 for the tunnel interface of Sysname 1.
<Sysname1> system-view
[Sysname1] interface tunnel 1 mode gre
[Sysname1-Tunnel1] source 193.101.1.1
[Sysname1-Tunnel1] destination 192.100.1.1
# Configure the source address 192.100.1.1 and destination address 193.101.1.1 for the tunnel interface
of Sysname 2.
<Sysname2> system-view
[Sysname2] interface tunnel 1 mode gre
[Sysname2-Tunnel1] source 192.100.1.1
[Sysname2-Tunnel1] destination 193.101.1.1
Related commands
• display interface tunnel
• interface tunnel