HP MSR2000/3000/4000 Router Series Layer 3 - IP Services Configuration Guide

181
• RFC 2460, Internet Protocol, Version 6 (IPv6) Specification
• RFC 2463, Internet Control Message Protocol (ICMPv6) for the Internet Protocol Version 6 (IPv6)
Specification
• RFC 2464, Transmission of IPv6 Packets over Ethernet Networks
• RFC 2526, Reserved IPv6 Subnet Anycast Addresses
• RFC 3307, Allocation Guidelines for IPv6 Multicast Addresses
• R FC 3 513 , Internet Protocol Version 6 (IPv6) Addressing Architecture
• R F C 4191, Default Router Preferences and More-Specific Routes
• RFC 4861, Neighbor Discovery for IP Version 6 (IPv6)
• RFC 4862, IPv6 Stateless Address Autoconfiguration
IPv6 basics configuration task list
Tasks at a
g
lance
(Required.) Assigning IPv6 addresses to interfaces:
• Configuring an IPv6 global unicast address
• Configuring an IPv6 link-local address
• Configuring an IPv6 anycast address
(Optional.) Configuring IPv6 ND:
• Configuring a static neighbor entry
• Setting the maximum number of dynamic neighbor entries
• Setting the aging timer for ND entries in stale state
• Minimizing link-local ND entries
• Setting the hop limit
• Configuring parameters for RA messages
• Configuring the maximum number of attempts to send an NS message for DAD
• Enabling ND proxy
(Optional.) Configuring path MTU discovery:
• Configuring the interface MTU
• Configuring a static path MTU for a specific IPv6 address
• Configuring the aging time for dynamic path MTUs
(Optional.) Controlling sending ICMPv6 packets:
• Configuring the rate limit for ICMPv6 error messages
• Enabling replying to multicast echo requests
• Enabling sending ICMPv6 destination unreachable messages
• Enabling sending ICMPv6 time exceeded messages
• Enabling sending ICMPv6 redirect messages
• Specifying the source address for ICMPv6 packets