HP MSR2000/3000/4000 Router Series Layer 3 - IP Services Configuration Guide

213
Ste
p
Command Remarks
3. Specify an IPv6 subnet for
dynamic assignment.
network prefix/prefix-length
[ preferred-lifetime preferred-lifetime
valid-lifetime valid-lifetime ]
By default, no IPv6 subnet is
specified.
4. (Optional.) Specify a DNS
server address.
dns-server ipv6-address
By default, no DNS server
address is specified.
5. (Optional.) Specify a domain
name suffix.
domain-name domain-name
By default, no domain name
suffix is specified.
6. (Optional.) Specify a SIP
server address or domain
name.
sip-server { address ipv6-address |
domain-name domain-name }
By default, no SIP server
address or domain name is
specified.
7. (Optional.) Configure a
self-defined DHCPv6 option.
option code hex hex-string
By default, no self-defined
DHCPv6 option is configured.
Configuring the DHCPv6 server on an interface
Enable the DHCP server and configure one of the following address/prefix assignment methods on an
interface:
• Apply an address pool on the interface—The DHCPv6 server selects an IPv6 address/prefix from
the applied address pool for a requesting client. If there is no assignable IPv6 address/prefix in the
address pool, the DHCPv6 server cannot to assign an IPv6 address/prefix to a client.
• Configure global address assignment on the interface—The DHCPv6 server selects an IPv6
address/prefix in the global DHCPv6 address pool that matches the server interface address or the
DHCPv6 relay agent address for a requesting client.
If you configure both methods on an interface, the DHCPv6 server uses the specified address pool for
address assignment without performing global address assignment.
Configuration guidelines
• An interface cannot serve as a DHCPv6 server and DHCPv6 relay agent at the same time.
• Do not enable DHCPv6 server and DHCPv6 client on the same interface.
• If you use the ipv6 dhcp server command multiple times, the most recent configuration takes effect.
• You can apply an address pool that has not been created to an interface. The setting takes effect
after the address pool is created.
• Only one address pool can be applied to an interface. If you use the ipv6 dhcp server apply pool
command multiple times, the most recent configuration takes effect.
Configuration procedure
To configure the DHCPv6 server on an interface:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A