4000 Router Series MPLS Command Reference

ct0: Specifies CT 0 for the static CR-LSP.

ct1: Specifies CT 1 for the static CR-LSP.

ct2: Specifies CT 2 for the static CR-LSP.

ct3: Specifies CT 3 for the static CR-LSP.

bandwidth-value: Specifies the bandwidth required by the static CRLSP, in the range of 1 to 4294967295

kbps. The default is 0 kbps.

Usage guidelines

The nexthop address specified for the static CRLSP cannot be a public IP address on the local device.

CT 2 and CT 3 are valid only in IETF DS-TE mode. In prestandard DS-TE mode, CT 2 and CT 3 are invalid

and the tunnel cannot be established.

Examples

# Configure a static CRLSP on the transit node, and configure its name as static-te-3, incoming label as

123, nexthop IP address as 1.1.1.1, outgoing label as 253, CT as CT 0, and required bandwidth as 20

kbps.

<Sysname> system-view

[Sysname] static-cr-lsp transit static-te-3in-label 123 nexthop 1.1.1.1 out-label 253

bandwidth ct0 20

Related commands

• display mpls static-cr-lsp

• static-cr-lsp egress

• static-cr-lsp ingress