HP MSR2000/3000/4000 Router Series MPLS Command Reference

121
Sender Template:
Sender address: 10.11.112.140 LSP ID: 5
Table 41 Command output
Field Descri
p
tion
Destination Tunnel destination address.
Source LSR ID of the device at the tunnel source end.
Style
Resource reservation style:
• SE—Shared-explicit style.
• FF—Fixed-filter style.
Sender address Sender address identifies the tunnel source end.
FRR desired State of FRR: enabled or disabled.
Upstream label Incoming label of the forward LSP.
Previous hop LIH Logical interface handle of the previous hop.
QoS service QoS service type: Controlled-Load or Guaranteed.
Recv message Epoch Value of the Epoch field in the Message ID object of the received message.
Recv message ID Message ID in the received message.
Send message epoch Value of the Epoch field in the Message ID object of the sent message.
Send message ID Message ID in the sent message.
In-Interface Incoming interface of the message.
Local LIH Local logical interface handle.
Local address IP address of the outgoing interface of the Path message.
Refresh interval Refresh interval for Path and Resv messages, in milliseconds.
Out-Interface Outgoing interface of the message.
Unknown object number Number of unknown objects.
Receive ERO number
Number of received Explicit Route Objects (EROs) and the ERO information.
ERO information includes the addresses of the nodes on the explicit path,
and whether the current node is a loose or strict next hop.
Send ERO number
Number of sent EROs and the ERO information.
ERO information includes the addresses of the nodes on the explicit path,
and whether the current node is a loose or strict next hop.
RRO number
Number of RROs.
If the number is not 0, the subsequent output displays the IP addresses or
labels recorded in the RROs.
The RRO information is displayed only when route recording is configured
on the tunnel interface.