HP MSR2000/3000/4000 Router Series MPLS Command Reference

186
simply-alert: Specifies that when routes exceed the maximum number, the system still accepts routes but
generates a system log message.
Usage guidelines
A limit configured in VPN instance view applies to both the IPv4 VPN and the IPv6 VPN.
A limit configured in IPv4 VPN view or IPv6 VPN view applies to only the IPv4 VPN or the IPv6 VPN.
IPv4/IPv6 VPN prefers the limit configured in IPv4/IPv6 VPN view over the limit configured in VPN
instance view.
Examples
# Specify that VPN instance vpn1 supports up to 1000 routes, and when routes exceed the upper limit,
can receive new routes but generates a system log message.
<Sysname> system-view
[Sysname] ip vpn-instance vpn1
[Sysname-vpn-instance-vpn1] route-distinguisher 100:1
[Sysname-vpn-instance-vpn1] routing-table limit 1000 simply-alert
# Specify that the IPv4 VPN vpn2 supports up to 1000 routes, and when routes exceed the upper limit,
can receive new routes but generates a system log message.
<Sysname> system-view
[Sysname] ip vpn-instance vpn2
[Sysname-vpn-instance-vpn2] route-distinguisher 100:2
[Sysname-vpn-instance-vpn2] address-family ipv4
[Sysname-vpn-ipv4-vpn2] routing-table limit 1000 simply-alert
# Specify that the IPv6 VPN vpn3 supports up to 1000 routes, and when routes exceed the upper limit,
can receive new routes but generates a system log message.
<Sysname> system-view
[Sysname] ip vpn-instance vpn3
[Sysname-vpn-instance-vpn3] route-distinguisher 100:3
[Sysname-vpn-instance-vpn3] address-family ipv6
[Sysname-vpn-ipv4-vpn3] routing-table limit 1000 simply-alert
sham-link
Use sham link to create an OSPF sham link.
Use undo sham link to remove a sham link or restore the defaults of specified parameters for a sham link.
Syntax
sham-link source-ip-address destination-ip-address [ cost cost | dead dead-interval | hello hello-interval
| { { hmac-md5 | md5 } key-id { cipher cipher-string | plain plain-string } | simple { cipher cipher-string
| plain plain-string } } | retransmit retrans-interval | trans-delay delay ] *
undo sham-link source-ip-address destination-ip-address [ cost | dead | hello | { { hmac-md5 | md5 }
key-id | simple } | retransmit | trans-delay ] *
Default
No OSPF sham link is configured.
Views
OSPF area view