HP MSR2000/3000/4000 Router Series MPLS Command Reference

65
If you set the interval to 0, the periodical flooding function is disabled. If you set the interval to a value
less than 30 seconds (1 to 29 seconds), the device automatically sets the interval to 30 seconds.
After you execute this command, the configured interval takes effect immediately.
Examples
# Configure IGP to flood TE information every 100 seconds.
<Sysname> system-view
[Sysname] mpls te
[Sysname-te] link-management periodic-flooding timer 100
Related commands
mpls te bandwidth change thresholds
mpls te
Use mpls te to enable MPLS TE for the local node and enter MPLS TE view.
Use undo mpls te to disable MPLS TE for the local node.
Syntax
mpls te
undo mpls te
Default
MPLS TE is disabled.
Views
System view
Predefined user roles
network-admin
Usage guidelines
Disabling MPLS TE also deletes all CRLSPs and MPLS TE configurations on the device.
Examples
# Enable MPLS TE for the local node and enter MPLS TE view.
<Sysname> system-view
[Sysname] mpls lsr-id 1.1.1.9
[Sysname] mpls te
[Sysname-te]
Related commands
mpls te enable
mpls te affinity-attribute
Use mpls te affinity-attribute to configure an affinity for a tunnel.
Use undo mpls te affinity-attribute to restore the default.