HP MSR2000/3000/4000 Router Series MPLS Command Reference

88
Related commands
• display mpls te tunnel-interface
• mpls te static-cr-lsp
mpls te static-cr-lsp
Use mpls te static-cr-lsp to reference a static CRLSP for a tunnel.
Use undo mpls te static-cr-lsp to remove the reference of the specified static CRLSP.
Syntax
mpls te static-cr-lsp lsp-name
undo mpls te static-cr-lsp lsp-name
Default
A tunnel does not reference any static CRLSP.
Views
Tunnel interface view
Predefined user roles
network-admin
Parameters
lsp-name: Specifies a static CRLSP by its name, a case-sensitive string of 1 to 15 characters.
Usage guidelines
This command takes effect only when the mpls te signaling static command has been configured in
tunnel interface view.
Execute this command on the ingress node. The static CRLSP specified in this command must have been
created by using the static-cr-lsp ingress command.
Examples
# Configure tunnel 0 to reference static CRLSP named static-te-3.
<Sysname> system-view
[Sysname] interface tunnel 0 mode mpls-te
[Sysname-Tunnel0] mpls te static-cr-lsp static-te-3
Related commands
• display mpls te tunnel-interface
• mpls te signaling
• static-cr-lsp egress
• static-cr-lsp ingress
• static-cr-lsp transit
mpls te timer retry
Use mpls te timer retry to configure the tunnel setup retry interval.
Use undo mpls te timer retry to restore the default.