HP MSR2000/3000/4000 Router Series MPLS Configuration Guide

96
Ste
p
Command Remarks
2. Enter RSVP view.
rsvp N/A
3. Create an RSVP
authentication neighbor and
enter RSVP neighbor view.
peer ip-address
By default, the device does not
have any RSVP authentication
neighbors.
4. Enable RSVP authentication
for the RSVP neighbor and
specify the authentication key.
authentication key { cipher |
plain } auth-key
By default, RSVP authentication is
disabled.
5. Enable challenge-response
handshake for the RSVP
neighbor.
authentication challenge
By default, the challenge-response
handshake function is disabled.
6. Configure the idle timeout for
the RSVP security associations
with the RSVP neighbor.
authentication lifetime life-time
By default, the idle timeout is 1800
seconds (30 minutes).
7. Specify the maximum number
of out-of-sequence
authenticated RSVP messages
that can be received from the
RSVP neighbor.
authentication window-size
number
By default, only one authenticated
RSVP message can be received out
of sequence.
To configure RSVP authentication in interface view:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Enable RSVP authentication
on the interface and configure
the authentication key.
rsvp authentication key { cipher |
plain } auth-key
By default, RSVP authentication is
disabled.
Do not enable both RSVP
authentication and FRR on the
same interface.
4. Enable challenge-response
handshake on the interface.
rsvp authentication challenge
By default, the challenge-response
handshake function is disabled.
5. Configure the idle timeout for
RSVP security associations on
the interface.
rsvp authentication lifetime
life-time
By default, the idle timeout is 1800
seconds (30 minutes).
6. Specify the maximum number
of out-of-sequence
authenticated RSVP messages
that can be received on the
interface.
rsvp authentication window-size
number
By default, only one authenticated
RSVP message can be received out
of sequence.
To configure RSVP authentication in RSVP view:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter RSVP view.
rsvp N/A