HP MSR2000/3000/4000 Router Series MPLS Configuration Guide

148
Perform the following configurations on the MCE. For information about how to configure the PE, see
"Configuring routing between a PE and a CE."
Configuring static routing between an MCE and a PE
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure a static route
for a VPN instance.
ip route-static vpn-instance s-vpn-instance-name
dest-address { mask | mask-length } { next-hop-address
[ public ] [ track track-entry-number ] | interface-type
interface-number [ next-hop-address ] | vpn-instance
d-vpn-instance-name next-hop-address [ track
track-entry-number ] } [ permanent ] [ preference
preference-value ] [ tag tag-value ] [ description
description-text ]
By default, no static
route is configured.
3. (Optional.) Configure
the default preference for
static routes.
ip route-static default-preference
default-preference-value
The default
preference is 60.
Configuring RIP between an MCE and a PE
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a RIP process for
a VPN instance and
enter RIP view.
rip [ process-id ] vpn-instance
vpn-instance-name
N/A
3. Enable RIP on the
interface attached to
the specified network.
network network-address
By default, RIP is disabled on
an interface.
4. Redistribute the VPN
routes.
import-route protocol [ process-id |
all-processes | allow-ibgp ] [ cost cost |
route-policy route-policy-name | tag tag ] *
By default, no routes are
redistributed into RIP.
5. (Optional.) Configure
the default cost for
redistributed routes.
default cost value The default cost is 0.
Configuring OSPF between an MCE and a PE
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an OSPF process for a
VPN instance and enter OSPF
view.
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
N/A