HP MSR2000/3000/4000 Router Series MPLS Configuration Guide

227
Ste
p
Command Remarks
8. (Optional.) Enable route
reflection between clients.
reflect between-clients
By default, route reflection
between clients is enabled.
9. (Optional.) Configure the cluster
ID for the RR.
reflector cluster-id { cluster-id |
ip-address }
By default, the RR uses its own
router ID as the cluster ID.
If multiple RRs exist in a cluster,
use this command to configure
the same cluster ID for all RRs in
the cluster to avoid routing loops.
2. Configure the CE:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Configure the PE as an IBGP
peer.
peer { group-name |
ipv6-address } as-number
as-number
By default, no BGP peer is created.
4. Create and enter BGP IPv6
unicast family view.
address-family ipv6 [ unicast ] N/A
5. Enable IPv6 unicast route
exchange with the specified peer
or peer group.
peer { group-name |
ipv6-address } enable
By default, BGP does not
exchange IPv6 unicast routes with
any peer.
6. (Optional.) Configure route
redistribution.
import-route protocol
[ process-id [ med med-value |
route-policy route-policy-name ]
* ]
A CE must redistribute its routes to
the PE so the PE can advertise them
to the peer CE.
Configuring routing between PEs
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Configure the remote PE as
the peer.
peer { group-name |
ipv6-address } as-number
as-number
By default, no BGP peer is
configured.
4. Specify the source interface
for route update packets sent
to the specified peer.
peer { group-name | ip-address }
connect-interface interface-type
interface-number
By default, BGP uses the outbound
interface of the best route destined
to the BGP peer as the source
interface.
5. Enter BGP-VPNv6 address
family view.
address-family vpnv6 N/A
6. Enable BGP-VPNv6 route
exchange with the specified
peer.
peer { group-name | ip-address }
enable
By default, BGP does not exchange
BGP-VPNv6 routes with any peer.