HP MSR2000/3000/4000 Router Series MPLS Configuration Guide

228
Configuring BGP VPNv6 route control
BGP VPNv6 route control is configured similarly with BGP route control, except that it is configured in
BGP-VPNv6 address family view. For detailed information about BGP route control, see Layer 3—IP
Routing Configuration Guide.
To configure BGP VPNv6 route control:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter BGP-VPNv6 address
family view.
address-family vpnv6 N/A
4. (Optional.) Configure filtering
of advertised routes.
filter-policy { acl6-number |
prefix-list ipv6-prefix-name }
export [ protocol process-id ]
By default, the PE does not filter
advertised routes.
5. (Optional.) Configure filtering
of received routes.
filter-policy { acl6-number |
prefix-list ipv6-prefix-name }
import
By default, the PE does not filter
received routes.
6. Configure ACL-based route
filtering for the specified peer
or peer group.
peer { group-name | ip-address }
filter-policy acl6-number { export |
import }
By default, no ACL-based route
filtering is configured.
7. Configure IPv6 prefix
list-based route filtering for the
specified peer or peer group.
peer { group-name | ip-address }
prefix-list ipv6-prefix-name
{ export | import }
By default, no IPv6 prefix list-based
route filtering is configured.
8. Specify a preferred value for
routes received from the peer
or peer group.
peer { group-name | ip-address }
preferred-value value
The default preferred value is 0.
9. Configure BGP updates sent
to the peer to carry only
public AS numbers.
peer { group-name | ip-address }
public-as-only
By default, a BGP update carries
both public and private AS
numbers.
10. Apply a routing policy to
routes advertised to or
received from the peer or peer
group.
peer { group-name | ip-address }
route-policy route-policy-name
{ export | import }
By default, no routing policy is
applied for a peer.
11. Enable route target filtering
for received BGP-VPNv6
routes.
policy vpn-target
By default, route target filtering is
enabled.
12. Configure the local PE as the
route reflector and specify the
peer as the client.
peer { group-name | ip-address }
reflect-client
By default, no route reflector or
client is configured.
13. Enable route reflection
between clients.
reflect between-clients
By default, route reflection
between clients is enabled.