HP MSR2000/3000/4000 Router Series MPLS Configuration Guide

232
to be exchanged between the MCE and the sites through different RIPng processes, ensuring the
separation and security of IPv6 VPN routes.
For more information about RIPng, see Layer 3—IP Routing Configuration Guide.
To configure RIPng between an MCE and a VPN site:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a RIPng process for a
VPN instance and enter RIPng
view.
ripng [ process-id ] vpn-instance
vpn-instance-name
Perform this configuration on the
MCE. On a VPN site, configure
normal RIPng.
3. Redistribute remote site routes
advertised by the PE.
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost |
route-policy route-policy-name ] *
By default, no routes are
redistributed into RIPng.
4. (Optional.) Configure the
default cost value for the
redistributed routes.
default cost value The default value is 0.
5. Return to system view.
quit N/A
6. Enter interface view.
interface interface-type
interface-number
N/A
7. Enable RIPng on the interface.
ripng process-id enable RIPng is disabled by default.
Configuring OSPFv3 between an MCE and a VPN site
An OSPFv3 process belongs to the public network or a single IPv6 VPN instance. If you create an
OSPFv3 process without binding it to an IPv6 VPN instance, the process belongs to the public network.
By configuring OSPFv3 process-to-IPv6 VPN instance bindings on a MCE, you allow routes of different
IPv6 VPNs to be exchanged between the MCE and the sites through different OSPFv3 processes,
ensuring the separation and security of IPv6 VPN routes.
For more information about OSPFv3, see Layer 3—IP Routing Configuration Guide.
To configure OSPFv3 between an MCE and a VPN site:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an OSPFv3 process for
a VPN instance and enter
OSPFv3 view.
ospfv3 [ process-id | vpn-instance
vpn-instance-name ] *
Perform this configuration on the
MCE. On a VPN site, configure
common OSPFv3.
The maximum number of OSPF
processes that a VPN instance can
run depends on the device's
memory.
Deleting a VPN instance also
deletes all related OSPFv3
processes.
3. Set the router ID.
router-id router-id N/A