HP MSR2000/3000/4000 Router Series MPLS Configuration Guide

236
Ste
p
Command Remarks
4. Enter BGP-VPN IPv6 unicast
address family view.
address-family ipv6 [ unicast ] N/A
5. Enable BGP to exchange IPv6
unicast routes with the peer.
peer { group-name | ipv6-address }
enable
By default, BGP does not
exchange IPv6 unicast routes
with any peer.
6. Redistribute the IGP routes of the
VPN into BGP.
import-route protocol [ process-id
[ med med-value | route-policy
route-policy-name ] * ]
By default, no routes are
redistributed into BGP.
A VPN site must advertise
VPN network addresses to the
connected MCE.
Configuring routing between an MCE and a PE
MCE-PE routing configuration includes these tasks:
• Binding the MCE-PE interfaces to IPv6 VPN instances.
• Performing routing configurations.
• Redistributing IPv6 VPN routes into the routing protocol running between the MCE and the PE.
Perform the following configuration tasks on the MCE. Configurations on the PE are similar to those on the
PE in common IPv6 MPLS L3VPN networks. For more information, see "Configuring routing between a PE
and a CE."
Configuring IPv6 static routing between an MCE and a PE
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure an IPv6 static
route for an IPv6 VPN
instance.
ipv6 route-static vpn-instance s-vpn-instance-name
ipv6-address prefix-length { interface-type
interface-number [ next-hop-address ] | nexthop-address
[ public ] | vpn-instance d-vpn-instance-name
nexthop-address } [ permanent ] [ preference
preference-value ] [ tag tag-value ] [ description
description-text ]
By default, no IPv6
static route is
configured.
3. (Optional.) Configure
the default preference
for IPv6 static routes.
ipv6 route-static default-preference
default-preference-value
The default value is
60.
Configuring RIPng between an MCE and a PE
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a RIPng process for an
IPv6 VPN instance and enter
RIPng view.
ripng [ process-id ] vpn-instance
vpn-instance-name
N/A