HP MSR2000/3000/4000 Router Series MPLS Configuration Guide
238
Ste
p
Command
Remarks
5. (Optional.) Redistribute VPN
routes.
ipv6 import-route protocol
[ process-id ] [ allow-ibgp ] [ cost
cost | [ level-1 | level-1-2 |
level-2 ] | route-policy
route-policy-name | tag tag ] *
By default, IPv6 IS-IS does not
redistribute routes from any other
routing protocol.
If you do not specify the route level
in the command, the command
redistributes routes to the level-2
routing table.
6. (Optional.) Configure filtering
of advertised routes.
ipv6 filter-policy { acl6-number |
prefix-list prefix-list-name |
route-policy route-policy-name }
export [ protocol [ process-id ] ]
By default, IPv6 IS-IS does not filter
advertised routes.
7. Return to system view.
quit N/A
8. Enter interface view.
interface interface-type
interface-number
N/A
9. Enable the IPv6 IS-IS process
on the interface.
isis ipv6 enable [ process-id ]
By default, IPv6 IS-IS is disabled on
an interface.
Configuring EBGP between an MCE and a PE
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter BGP-VPN view.
ip vpn-instance vpn-instance-name
N/A
4. Configure the PE as an EBGP
peer.
peer { group-name |
ipv6-address } as-number
as-number
By default, no BGP peer is
configured.
5. Enter BGP-VPN IPv6 unicast
address family view.
address-family ipv6 [ unicast ] N/A
6. Enable BGP to exchange IPv6
unicast routes with the
specified peer.
peer { group-name | ip-address }
enable
By default, BGP does not exchange
IPv6 unicast routes with any peer.
7. Redistribute VPN routes.
import-route protocol [ process-id
[ med med-value | route-policy
route-policy-name ] * ]
By default, no routes are
redistributed into BGP.
8. (Optional.) Configure filtering
of advertised routes.
filter-policy { acl6-number |
prefix-list ipv6-prefix-name }
export [ protocol process-id ]
By default, BGP does not filter
advertised routes.
9. (Optional.) Configure filtering
of received routes.
filter-policy { acl6-number |
prefix-list ipv6-prefix-name }
import
By default, BGP does not filter
received routes.
Configuring IBGP between an MCE and a PE
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A