4000 Router Series MPLS Configuration Guide

ManualsBrandsHP ManualsNetwork HardwareHP MSR3024 TAA-compliant AC Router

281

282

283

284

285

286

287

288

289

290

274

Destination: FE80::/10 Protocol : Direct

NextHop : :: Preference: 0

Interface : NULL0 Cost : 0

Destination: FF00::/8 Protocol : Direct

NextHop : :: Preference: 0

Interface : NULL0 Cost : 0

The output shows that the MCE has learned the private route of VPN 2 through RIPng. The MCE

maintains the routes of VPN 1 and VPN 2 in two different routing tables. In this way, routes from

different VPNs are separated.

3. Configure routing between the MCE and PE 1:

# The MCE is connected to PE 1 through subinterfaces. On the MCE, bind subinterface Ethernet

1/3.1 with the VPN instance vpn1, configure the subinterface to terminate VLAN 10, and

configure an IPv6 address for the subinterface.

[MCE] interface ethernet 1/3.1

[MCE-Ethernet1/3.1] ip binding vpn-instance vpn1

[MCE-Ethernet1/3.1] vlan-type dot1q vid 10

[MCE-Ethernet1/3.1] ipv6 address 2001:2::3 64

[MCE-Ethernet1/3.1] quit

# On the MCE, bind subinterface Ethernet 1/3.2 with the VPN instance vpn2, configure the

subinterface to terminate VLAN 20, and configure an IPv6 address for the subinterface.

[MCE] interface ethernet 1/3.2

[MCE-Ethernet1/3.2] ip binding vpn-instance vpn2

[MCE-Ethernet1/3.2] vlan-type dot1q vid 20

[MCE-Ethernet1/3.2] ipv6 address 2002:2::3 64

[MCE-Ethernet1/3.2] quit

# On PE 1, bind subinterface Ethernet 1/1.1 with the VPN instance vpn1, configure the

subinterface to terminate VLAN 10, and configure an IPv6 address for the subinterface.

[PE1] interface ethernet 1/1.1

[PE1-Ethernet1/1.1] ip binding vpn-instance vpn1

[PE1-Ethernet1/1.1] vlan-type dot1q vid 10

[PE1-Ethernet1/1.1] ipv6 address 2001:2::4 64

[PE1-Ethernet1/1.1] quit

# On PE 1, bind subinterface Ethernet 1/1.2 with the VPN instance vpn2, configure the

subinterface to terminate VLAN 20, and configure an IPv6 address for the subinterface.

[PE1] interface ethernet 1/1.2

[PE1-Ethernet1/1.2] ip binding vpn-instance vpn2

[PE1-Ethernet1/1.2] vlan-type dot1q vid 20

[PE1-Ethernet1/1.2] ipv6 address 2002:2::4 64

[PE1-Ethernet1/1.2] quit

# Configure the IP address of the interface Loopback0 as 101.101.10.1 for the MCE and as

100.100.10.1 for PE 1. Specify the loopback interface address as the router ID for the MCE and

PE 1. (Details not shown.)

# Enable OSPFv3 process 10 on the MCE, bind the process to VPN instance vpn1, and

redistribute the IPv6 static route of VPN 1.

[MCE] ospfv3 10 vpn-instance vpn1