4000 Router Series MPLS Configuration Guide

Ingress LSR ID : 1.1.1.1 Egress LSR ID : 3.3.3.3

Signaling : Static Static CRLSP Name : static-cr-lsp-1

Resv Style : -

Tunnel mode : -

Reverse-LSP name : -

Reverse-LSP LSR ID : - Reverse-LSP Tunnel ID: -

Class Type : - Tunnel Bandwidth : -

Reserved Bandwidth : -

Setup Priority : 0 Holding Priority : 0

Affinity Attr/Mask : -/-

Explicit Path : -

Backup Explicit Path : -

Metric Type : IGP

Record Route : - Record Label : -

FRR Flag : - Backup Bandwidth Flag: -

Backup Bandwidth Type: - Backup Bandwidth : -

Route Pinning : -

Retry Limit : 10 Retry Interval : 2 sec

Reoptimization : - Reoptimization Freq : -

Backup Type : - Backup LSP ID : -

Auto Bandwidth : - Auto Bandwidth Freq : -

Min Bandwidth : - Max Bandwidth : -

Collected Bandwidth : -

# Execute the display mpls lsp command or the display mpls static-cr-lsp command on each router to

display the static CRLSP information.

[RouterA] display mpls lsp

FEC Proto In/Out Label Interface/Out NHLFE

1.1.1.1/0/1 StaticCR -/20 Eth1/1

2.1.1.2 Local -/- Eth1/1

[RouterB] display mpls lsp

FEC Proto In/Out Label Interface/Out NHLFE

- StaticCR 20/30 Eth1/2

3.2.1.2 Local -/- Eth1/2

[RouterC] display mpls lsp

FEC Proto In/Out Label Interface/Out NHLFE

- StaticCR 30/- -

[RouterA] display mpls static-cr-lsp

Name LSR Type In/Out Label Out Interface State

static-cr-lsp-1 Ingress Null/20 Eth1/1 Up

[RouterB] display mpls static-cr-lsp

Name LSR Type In/Out Label Out Interface State

static-cr-lsp-1 Transit 20/30 Eth1/2 Up

[RouterC] display mpls static-cr-lsp

Name LSR Type In/Out Label Out Interface State

static-cr-lsp-1 Egress 30/Null - Up

# Execute the display ip routing-table command on Router A. You can see a static route entry with

interface Tunnel0 as the egress interface.