4000 Router Series MPLS Configuration Guide

ManualsBrandsHP ManualsNetwork HardwareHP MSR3024 TAA-compliant AC Router

100

Ste

Command

Remarks

1. Enter system view.

system-view N/A

2. Create a static CRLSP.

• Configure the ingress node:

static-cr-lsp ingress lsp-name { nexthop

next-hop-addr | outgoing-interface

interface-type interface-number }

out-label out-label-value [ bandwidth

[ ct0 | ct1 | ct2 | ct3 ]

bandwidth-value ]

• Configure a transit node:

static-cr-lsp transit lsp-name in-label

in-label-value { nexthop next-hop-addr |

outgoing-interface interface-type

interface-number } out-label

out-label-value [ bandwidth [ ct0 | ct1 |

ct2 | ct3 ] bandwidth-value ]

• Configure the egress node:

static-cr-lsp egress lsp-name in-label

in-label-value

Use one command according to

the position of a device on the

network.

By default, no static CRLSP

exists.

Do not configure the next hop

address as a local public IP

address when configuring the

static CRLSP on the ingress

node or a transit node.

You do not need to execute the

static-cr-lsp egress command

on the egress node if the

outgoing label configured on

the penultimate hop of the static

CRLSP is 0 or 3.

Displaying static CRLSPs

Execute display commands in any view.

Task Command

Display static CRLSP information. display mpls static-cr-lsp [ lsp-name lsp-name ] [ verbose ]

Static CRLSP configuration example

Network requirements

Router A, Router B, and Router C run IS-IS.

Establish an MPLS TE tunnel over a static CRLSP from Router A to Router C.