4000 Router Series Network Management and Monitoring Command Reference

254

action reboot

Use action reboot to add a reboot action to a monitor policy.

Use undo action to remove an action.

Syntax

MSR2000/MSR3000:

action number reboot [ subslot subslot-number ]

undo action number

MSR4000:

action number reboot [ slot slot-number [ subslot subslot-number ] ]

undo action number

Default

Monitor policies do not contain any actions.

Views

CLI-defined policy view

Predefined user roles

network-admin

Parameters

number: Specifies an action ID in the range of 0 to 231.

slot slot-number: Specifies a card by its slot number. If no card is specified, the command reboots all

cards in the specified chassis. (MSR4000.)

subslot subslot-number: Specifies a subcard by its slot number. If no subcard is specified, the command

reboots all subcards.

Usage guidelines

You can configure a series of actions to take in response to the event specified in a monitor policy.

EAA executes the actions in ascending order of action IDs. When you add actions to a policy, you must

make sure the execution order is correct.

The reboot action configured with this command reboots devices or cards without saving the running

configuration. If you want to save the running configuration, use the action cli command to configure

reboot actions.

You can specify EAA environment variable names instead of specifying specific values for an argument.

For more information about using EAA environment variables, see "rtm environment."

Examples

# Configure an action for the CLI-defined policy test to reboot the device.

<Sysname> system-view

[Sysname] rtm cli-policy test

[Sysname-rtm-test] action 3 reboot