4000 Router Series Network Management and Monitoring Command Reference

Views

DLSw operation view, FTP operation view, HTTP operation view, ICMP echo operation view, path jitter

operation view, SNMP operation view, TCP operation view, UDP echo operation view, DHCP operation

view, UDP jitter operation view, voice operation view, any NQA template view

Predefined user roles

network-admin

Parameters

ip-address: Specifies the source IP address of the operation.

Usage guidelines

If you configure both the source interface command and the source ip command, the source ip command

takes effect.

If you configure the source interface command but not the source ip command for the ICMP echo

operation, the IP address of the source interface serves as the source IP address of the probe packet.

The specified source IP address must be the IP address of a local interface. The local interface must be up.

Otherwise, no probe packets can be sent out.

Examples

# Configure the source IP address for ICMP echo requests as 10.1.1.1.

<Sysname> system-view

[Sysname] nqa entry admin test

[Sysname-nqa-admin-test] type icmp-echo

[Sysname-nqa-admin-test-icmp-echo] source ip 10.1.1.1

# In ICMP template view, configure the source IP address for ICMP echo requests as 10.1.1.1.

<Sysname> system-view

[Sysname] nqa template icmp icmptplt

[Sysname-nqatplt-icmp-icmptplt] source ip 10.1.1.1

Related commands

source interface

source ipv6

Use source ipv6 to configure the source IPv6 address for probe packets.

Use undo source ipv6 to remove the configured source IPv6 address. The IPv6 address of the interface

that sends a probe packet serves as the source IPv6 address of the probe packet.

Syntax

source ipv6 ipv6-address

undo source ipv6

Default

No source IPv6 address is configured for probe packets.

Views

Any NQA template view