4000 Router Series Network Management and Monitoring Command Reference

Predefined user roles

network-admin

Parameters

ipv6-address: Specifies the source IPv6 address of the operation.

Usage guidelines

If you configure both the source interface command and the source ipv6 command, the source ipv6

command takes effect.

If you configure the source interface command but not the source ipv6 command for the ICMP echo

operation, the IPv6 address of the source interface serves as the source IPv6 address of the probe packet.

The specified source IPv6 address must be the IPv6 address of a local interface. The local interface must

be up. Otherwise, no probe packets can be sent out.

Examples

# In ICMP template view, configure the source IPv6 address for ICMP echo requests as 1::1.

<Sysname> system-view

[Sysname] nqa template icmp icmptplt

[Sysname-nqatplt-icmp-icmptplt] source ipv6 1::1

Related commands

source interface

source port

Use source port to configure the source port for probe packets.

Use undo source port to remove the configured source port number.

Syntax

source port port-number

undo source port

Default

No source port number is configured for probe packets.

Views

SNMP operation view, UDP echo operation view, UDP jitter operation view, voice operation view, DNS

template view

Predefined user roles

network-admin

Parameters

port-number: Specifies the source port number in the range of 1 to 65535.

Examples

# Configure port 8000 as the source port for probe packets in the UDP echo operation.

<Sysname> system-view

[Sysname] nqa entry admin test

[Sysname-nqa-admin-test] type udp-echo