HP MSR2000/3000/4000 Router Series Network Management and Monitoring Configuration Guide

116
Displaying the SNMP settings
Execute display commands in any view.
Task Command
Display SNMP agent system information, including
the contact, physical location, and SNMP version.
display snmp-agent sys-info [ contact | location |
version ]
Display SNMP agent statistics. display snmp-agent statistics
Display the local engine ID. display snmp-agent local-engineid
Display SNMP group information. display snmp-agent group [ group-name ]
Display remote engine IDs.
display snmp-agent remote [ ip-address
[ vpn-instance vpn-instance-name ] | ipv6
ipv6-address [ vpn-instance vpn-instance-name ] ]
Display basic information about the notification
queue.
display snmp-agent trap queue
Display the modules that can generate notifications
and their notification status (enable or disable).
display snmp-agent trap-list
Display SNMPv3 user information.
display snmp-agent usm-user [ engineid engineid |
username user-name | group group-name ] *
Display SNMPv1 or SNMPv2c community
information. (This command is applicable only to
non-FIPS mode.)
display snmp-agent community [ read | write ]
Display MIB view information.
display snmp-agent mib-view [ exclude | include |
viewname view-name ]
Display SNMP MIB node information.
display snmp-agent mib-node [ details | index-node
| trap-node | verbose ]
SNMPv1/SNMPv2c configuration example
SNMPv1 configuration procedure is the same as the SNMPv2c configuration procedure. This example
uses SNMPv1, and is available only for non-FIPS mode.
Network requirements
As shown in Figure 43, t h e N M S (1.1.1. 2 / 2 4 ) u s e s S N M P v 1 t o m a n a g e t h e S N M P a g e n t (1.1.1.1 / 2 4 ) , a n d
the agent automatically sends notifications to report events to the NMS.
Figure 43 Network diagram
Configuration procedure
1. Configure the SNMP agent: