HP MSR2000/3000/4000 Router Series Network Management and Monitoring Configuration Guide

131
<filter type="subtree">
<top xmlns="http://www.hp.com/netconf/data:1.0">
<Ifmgr>
<Interfaces>
<Interface/>
</Interfaces>
</Ifmgr>
</top>
</filter>
</get-bulk>
</rpc>
</env:Body>
</env:Envelope>
How to use NETCONF
You can use NETCONF to manage and configure devices by using the methods in Table 10.
Table 10 NETCONF methods for configuring the device
Confi
g
uration tool Lo
g
in method Remarks
CLI
• Console port
• SSH
• Telnet
To implement NETCONF operations, copy valid
NETCONF messages to the CLI in XML view.
This method is suitable for R&D and test
purposes.
Custom Web interface N/A
To use this method, you must enable NETCONF
over SOAP.
Protocols and standards
• RFC 3339, Date and Time on the Internet: Timestamps
• RFC 4741, NETCONF Configuration Protocol
• RFC 4742, Using the NETCONF Configuration Protocol over Secure SHell (SSH)
• RFC 4743, Using NETCONF over the Simple Object Access Protocol (SOAP)
• RFC 5277, NETCONF Event Notifications
• RFC 5381, Experience of Implementing NETCONF over SOAP
• RFC 5539, NETCONF over Transport Layer Security (TLS)
• RFC 6241, Network Configuration Protocol
FIPS compliance
The device supports the FIPS mode that complies with NIST FIPS 140-2 requirements. Support for features,
commands, and parameters might differ in FIPS mode (see Security Configuration Guide) and non-FIPS
mode.